Publicidad
Idiomas disponibles
Idiomas disponibles
03 .
OPERATION IN CASE OF ACCIDENT
Do not swallow or allow skin to come into contact with fuel, oil, coolant, lubricants
or battery electrolyte.
If swallowed, seek medical treatment immediately. Do not induce vomiting if fuel is
swallowed. For skin contact, wash with soap and water.
Call for health care.
Do not expose a battery to fire or electric sparks. There is a risk of fire and explosion.
Call for health care.
Battery electrolyte is corrosive. Protect eyes, skin and clothing when handling
batteries.
On skin: wash with plenty of water and soap.
In the eyes: wash immediately with plenty of water.
Call for health care.
0 4 .
DELIVERY
Check condition of genset. In case of damage, record them on the document presented by
the carrier.
Check if the product matches with your order.
0 5 .
INSTALATION
GRUPEL generator sets are designed for safe and efficient use.
The generator set can be installed indoors or outdoors, always considering that the set
must be protected from rain and dust. In the case of a stationary group, it should not be
installed outdoors.
When installing a generator set the following precautions must be taken:
•
Adequate ventilation;
•
Enough distance to obstacles for proper cooling;
•
Enough distance to obstacles to facilitate access to maintenance;
•
Necessary and adequate protections;
•
Presence of extinguisher abroad;
•
Presence of extinguisher inside;
•
Sandbox;
•
Location forbidden to unauthorized persons.
Special care with:
•
Concrete massif: massif will absorb some of the vibrations caused by the engine, so it
should be sturdy enough to withstand its weight, as well as the forces that can be generat-
ed;
•
Ventilation: adequate ventilation must be provided at the installation site to allow
enough air inlet and outlet for proper cooling of the unit.
•
Extraction gases, in pipeline directing gaseous effluents: it is important to channel the
hot air from the radiator to the outside. Otherwise it may increase the air temperature
around the group and cause it to stop due to lack of cooling;
•
Grounding: this must be done in accordance with the regulations of the country of
installation in order to avoid the appearance of voltages in the metal masses due to,
among other possible causes, insulation defects.
021
Publicidad
