Publicidad
Idiomas disponibles
Idiomas disponibles
0 7.
ATS / QTC – AUTOMATIC TRANSFER SWITCH
There are two types of Automatic transfer Switch (ATS):
ATS IN - located inside the
generator's electrical panel
In the genset controller panel you can find:
1.
Source 1 (network);
2. Consumer (item to be loaded);
3. Source 2 (generator);
4. Power ON / OFF Switch;
5. Led access: ATS energized;
6. Led access: Generator will be / is activated;
7. Led access: Automatic mode triggered;
8. Led access: Manual mode triggered;
9. Button for setting Automatic or Manual mode.
If you have requested an ATS/QTC OUT, you must make the respective electrical power
connections:
a)
Mains input cables for order of color: blue (neutral), grey (Phase 1), black (Phase 2) and
brown (Phase 3);
b)
Output cables for the load, obeying the color order of the input.
024
ATS OUT - located outside
the generator
The electrical connections
to be made are:
Genset X2-21 / QTC F1
Genset X2-22 / QTC F2
Genset X2-23 / QTC F3
Genset X2-24 / QTC F4
Genset X2-25 / QTC 402
Genset X2-26 / QTC 404
Genset X2-91 / QTC 401
Publicidad
