Publicidad
Idiomas disponibles
Idiomas disponibles
1 Microphone/LED indicator
2 Multifunction button: press the multifunction
button to power the earbuds on and off. Also
press this button to enable/disable ANC and
transparency mode, play or pause media, and to
answer or end an incoming call
3 Charging case LED indicator: The four LED
lights showcase battery status
4 Charging port: insert the Type C cable in this
port to charge the battery
5 Earbuds charging area: the earbuds will
receive the charge in this area when wirelessly
charged
3. Basic operation
a. Charging the case and earbuds
1. To charge the case, plug the USB cable into
a power source and the Type C end into the
case's charging port. The case starts charging
automatically.
2. Charging the case battery to its full capacity
may take 1.5 hour.
3. The four LED lights are on for 30 seconds
and then turn off when the charging case is
fully charged.
4. Unplug the case from the power source and
place the earbuds on the sockets of the
charging case. The charging level is
showcased as follows:
- One LED light on indicates that the earbuds
have 25% charge
- Two LED lights on, indicate 50% charge
- Three LED lights on, indicate 75% charge
- Four LED lights on, indicate that the earbuds
are fully charged
IMPORTANT: The touch button
is sensitive. Therefore, please make
sure to manipulate the earbuds by
grabbing them from the arm to avoid
taping the touch button by accident.
b. Turning your earbuds on or o
1. The earbuds automatically turn on when
removed from the charging case or press and
hold the multifunction button on each one for
3 seconds to turn them on.
2. As both earbuds synchronize, a voice prompt
will be heard indicating that they are
connected.
3. To turn the earbuds off, place them in the
charging case and close the lid. To turn them
off manually, press and hold the multifunction
button on one of the earbuds for 5 seconds.
Publicidad
