Publicidad
Idiomas disponibles
Idiomas disponibles
4. INSTALLATION
4.4 Connection of incoming, outgoing and grounding conductors:
Tools
1.
Phillips #2 torque wrench bit;
2.
Phillips #2 screwdriver;
3.
Torque wrench.
Passo a passo sugerido
Suggested step-by-step
1.
Strip the conductor to a length of up to 12 mm;
2.
Turn the key counterclockwise until the terminal block cage is completely
open terminal block;
3.
Insert the stripped part of the conductor into the open wireway of the
terminal block;
4.
Turn the wrench clockwise until the wire is tight in the terminal block;
5.
With the torque wrench set at 3.0 ± 5% N.m.
Caution
Before handling electrical cables, make sure they are de-energized.
Caution
CLAMPER Indústria e Comércio S.A.
12 mm
1
www.clamper.com.br
3
16103133
|
+55 31 3689 9500
Page 34 of 44
Publicidad
