Publicidad
Idiomas disponibles
Idiomas disponibles
After checking the entered data once again, press either ENTER
ESCAPE
to delete the action and return to the previous screen display.
If the fitting connection has not been carried out yet, you will be prompted to carry it out in
the next screenshot.
After connecting the fitting, the next screenshot shows .the ohmnic resistance of the fitting.
After connecting the fitting press ENTER
The next screenshot shows a message reminding the operator that, before welding, all
the required preparatory actions must have been completed (scraping and cleaning).
You will also be reminded that, in order to ensure good welding, a pipe aligner must be
used. Press ENTER
At this point a summary of the information entered so far will be displayed as shown below:
By pressing ENTER
will be displayed:
A sound signal marks the end of the welding procedure and the information shown
opposite is displayed. Press the ARROW UP key
Press ENTER
to start a new welding procedure using the same data or alternatively
press ESCAPE
to enter new data.
to continue.
to continue or ESCAPE
you will start the welding procedure and the following screenshot
28
to confirm or
to return to the previous screenshot.
D
Time
Voltage
t.rem
Residual welding time in seconds
P
Power output in Watts
Welding progress %
U
Welding voltage in Volts
E
Dissipated energy in Joules
to display a detailed welding report.
Diameter of the fitting
Welding time in seconds
Welding voltage in Volts
Publicidad
