Publicidad
Idiomas disponibles
Idiomas disponibles
1.3 Connect and install the radio
Page 2 – Fig. 2
Note
In vehicles with Quadlock plug, an adapter Quadlock to ISO must be installed (not included in the scope of delivery,
must be ordered separately if required). Connect the adapter according to the enclosed assembly instructions.
Compartment assignment of the multiway connector II:
1 Loudspeaker rear right, plus
2 Loudspeaker rear right, minus
3 Loudspeaker front right, plus
4 Loudspeaker front right, minus
5 Loudspeaker front left, plus
6 Loudspeaker front left, minus
7 Loudspeaker rear left, plus
8 Loudspeaker rear left, minus
Compartment assignment of the multiway connector III:
4 Connection for switching on and off using the ignition key, terminal 15
5 Control signal for anti-theft protection (SAFE), terminal 30
6 Illuminated radio display, terminal 58d*
7 Power supply, plus, terminal 30
8 Power supply, minus, terminal 31
)
*
if the connection for the illumination is missing, connect 58d with terminal 15
Radio RMT 200 only:
Page 3 – Fig. 1
Note
The scope of delivery includes two different buffers -1-. The selection must be made depending on the equipment.
Screw the buffer -1- from the scope of delivery to the threaded hole on the rear of the radio.
Insert the aerial connector -2- on the rear side.
Push in the ISO connector -arrow- on the rear side of the radio and lock in place.
Push the radio into the installation bay until it clicks into place.
Radio RMT 300 only:
Page 3 – Fig. 2
Insert the radio into the installation bay of the vehicle and screw tight -arrows-.
Fit the coverings of the vehicle in reverse order.
ELSA; Rep.-Gr. 91
1.4 Radio removal
Radio RMT 200 only:
Page 3 – Fig. 3
Insert the release tools from the scope of delivery into the release slots -arrows- of the radio with the tips pointing
outwards, until they click into place.
Pull the radio out of the installation bay by holding onto the grip rings of the release tool.
Disconnect connectors on the radio.
Press the clip tabs on the radio inwards and pull out the release tools.
Radio RMT 300 only:
The removal of radio RMT 300 is carried out in the reverse order of the installation.
13
Publicidad
