Tecfrigo MELODIA Instalación Y Uso página 6

Operator's guide:
1)Unpacking instructions
2)Replacing the mirror
3)Opening the protective cover
4)Cleaning the stainless steel shelf
5)Cleaning the cover and external parts
6)Holders for containers and pastry shelves
7)Connection to the mains
!
WARNINGS
(Page 61)
It is most important that this instruction booklet is kept together with the appliance both for future
reference and for reasons of safety.
1 . Adults should operate this appliance only. Do not allow children to use the controls or play with it. . It
is forbidden to modify in any way the main functions and characteristics of this appliance. . The electrical
installation of the appliance should be carried out by a qualified electrician or other competent person.
4. Never attempt to carry out repairs unassisted. Inexpert repairs can cause serious damage and
malfunction. . Assistance has to be provided by an authorized engineer only. Always use original spare 5
6
parts. . This appliance is not suitable for the storage of basic commodities not including food-stuffs.
7. The manufacturers of this appliance accept no responsibility for the consequences of misuse in
contravention of these safety instructions. It further reserves the right to carry out improvements without
prior notice. 8 . Avoid installing the cabinet directly in line with sunlight. . Nevere install the appliance near
sources of heat, such as radiators, stoves, etc.
11
least 30 cm. . If damp air or products to be refrigerated should cause ice to form on the evaporator, we
recommend stopping the compressor and placing the goods in special refrigerated containers, kept at the
same temperature, until defrosting is completed;if this is not carried out the compressor will continue to
operate leading to a wasteful consumption of electricity and poor performance.
!
Our products are for internal use only – do not install outside restaurants, shops.
UNPACKING INSTRUCTIONS
1.
1a. Cut surrounding tape. Remove the cardboard package by sliding it upwards, remove the nails from
the wooden crate with care. . Insert forks of forklift truck between the appliance and pallet or crate.
the appliance. 4. Remove the pallet or crate. . Place the appliance on a flat, level surface.
there is nothing left in the package before disposing of it. . Sort out the packaging materials in order to
facilitate disposal. . The appliance can be locked in place by engaging the wheel brakes (see picture 1). 8
REPLACING THE MIRROR
2.
1. Switch off the appliance. . Unscrew the rear support screws. . Replace the mirror and put everything
back in reverse order (see figure 4).
OPENING THE PROTECTIVE COVER
3.
1. Plug the machine into the power supply socket. . Turn the switch of the electric lifting system (A) to
position II until the cover is fully
CLEANING THE STAINLESS STEEL SHELF
4.
1 . Clean the tank using a soft sponge and neutral detergent. .Turn the tap on to eliminate any residual water.
3. Dry with a soft cloth.
5. CLEANING THE COVER AND EXTERNAL PARTS
1. Never use detergents containing alcohol or solvents which would irremediably damage the cover,
compromising its transparency. . Use only a soft damp sponge. . As far as the wooden surfaces are
concerned, use proprietary detergents especially designed for wooden surfaces, which are water-based
and do not contain solvents. . Dry with a clean cloth.
6. HOLDERS FOR CONTAINERS AND PASTRY SHELVES
1
. Remove the protection film from the holders. . Place the longer holders in the slots provided on the
basin's rims (see picture 3). . Place the shorter holders in the slots provided in the longer holders.
Different arrangements are available for different container sizes and positions.
containers on the holders
rims (containers and stainless steel shelves are available upon demand) (see picture 3).
Operator's guide
10
. Keep the ventilation grills free from obstruction for at
2
5
2
2
2
4
2
3
. 5.
For pastry models, you need only place the stainless steel shelves on the
8)Operations and adjustment
9)Routine maintenance
10)Replacement of the lamp
Maintenance manual (Page 46):
1)Cleaning the condenser (skilled personnel only)
2)Replacement of the cover's lifting motor
3)Wiring diagram diagram of refrigeration unit
9
7
3
2
3
6
2
3
3.
Lift
6. Make sure
4.
You can now put your
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO