Trotec IRD 1200 Manual De Instrucciones página 132

Behaviour in the event of an emergency
1. Switch the device off.
2. In an emergency, disconnect the device from the mains
feed-in: Hold onto the mains plug while pulling the power
cable out of the mains socket.
3. Do not reconnect a defective device to the mains.
Information about the device
Device description
The infrared radiant heater (blacklight)
quickly generate heat without emitting light.
The device is based on the functional principle of heat
generation by infrared radiation. Persons or objects are heated
directly.
Via a stainless steel heating coil enclosed in aluminium, the
device emits most of its radiation energy in the long-wave
infrared spectrum. The device does not generate any dazzling
red light during operation. In addition, this type of heat
generation is also energy-saving. The full heating capacity is
only reached after approx. 10 min of operation. This is why the
device is classified as slow-acting with regard to its operating
principle.
The maximum effective range is approx. 2.7 metres. Wind and
draught, however, can reduce this effective range. For this
reason, it is recommended to use the device in outdoor areas
sheltered from the wind.
The 3 heating levels can be selected using the remote control.
The device indicates operation by means of two coloured LEDs.
Using the timer function the device can be switched off
automatically with time delay.
• suitable for outdoor use in areas sheltered from the wind
• IP55 type of protection – splash- and water-jet-proof
• suitable for mounting on walls and ceilings
• adjustable angle
• no dust circulation (suitable for allergy sufferers)
EN
IRD 1200 serves to
infrared radiant heater IRD 1200 / IRD 1800 / IRD 2400 / IRD 3200
Device depiction
5
No. Designation
1 Display with infrared receiver for remote control
2 On/off switch
3 Guide rail for device holder
4 Remote control
5 Aluminium cover
P1 P2
P3 TIMER
1
2
3
4
5