Trotec IRD 1200 Manual De Instrucciones página 140

The device does not emit heat:
• The heating element may be defective. If the heating
element is defective, have it replaced by a specialist
electrical company.
• Check the heating level on the segment display. If P0 is
displayed, the device is running in standby mode.
Switch the device on by selecting another heating level
between P1 and P3.
• Check the on/off switch. If the on/off switch is set to the 0
position, the device is switched off.
Switch the device on.
• Check the operating light. If the operating light flashes red,
the device is running in standby mode.
Switch on the device by selecting a heating level via the
remote control.
• Contact a specialist electrical company.
The heat output is low:
• Strong wind or cold temperatures in outdoor areas can
impair the device's heat output.
• Check whether the device is installed in the correct
position. The device may be installed too high or the
inclination angle may be incorrect.
• The device is undersized for the area to be heated.
• The heating rod might be defective. Have a defective
heating rod replaced by a specialist electrical company.
RCD or another fuse trips:
• Check the fuse. Switch off any other devices to reduce the
load on the line.
• Contact a specialist electrical company.
The device slightly vibrates during switch-on and then
stops vibrating:
• Slight vibrations during switch-on are a normal process.
No measures are required.
The device does not respond to the infrared remote control:
• Check whether the distance between remote control and
device is too large and reduce it if necessary.
• Make sure there are no obstacles, such as furniture or
walls, between the device and the remote control. Ensure
visual contact between device and remote control.
• Check the charging status of the batteries and change
them if required.
• If the batteries have just been changed, check them for
correct polarity.
Note
Wait for at least 10 minutes after maintenance and
repair work. Only then switch the device back on.
EN
The device still does not operate correctly after these
checks:
Please contact the customer service. If necessary, bring the
device to an authorised specialist electrical company or to
Trotec for repair.
Maintenance
Activities required before starting maintenance
• Switch the device off.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
• Allow the device to cool down completely.
Cleaning the device
Clean the device with a soft, damp and lint-free cloth. Ensure
that no moisture enters the housing. Protect electrical
components from moisture. Do not use any aggressive cleaning
agents such as cleaning sprays, solvents, alcohol-based or
abrasive cleaners to dampen the cloth.
Wipe the housing dry after cleaning.
infrared radiant heater IRD 1200 / IRD 1800 / IRD 2400 / IRD 3200
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
Warning of electrical voltage
Tasks which require the device to be opened must
only be carried out by authorised specialist
companies or by Trotec.
13