Publicidad
Idiomas disponibles
Idiomas disponibles
Assembling / Removing the pedestal
Preparations
Take out the pedestal(s) and the TV from the packing
case and put the TV onto a work table with the screen
panel down on the clean and soft cloth (blanket, etc.)
• Use a flat and firm table bigger than the TV.
• Do not hold the screen panel part.
• Make sure not to scratch or break the TV.
Assembling the pedestal
1.
The stand of the TV consists of two pieces. Install
these pieces together.
2.
Place the stand(s) on the stand mounting
pattern(s) on the rear side of the TV.
3.
Insert the screws
them gently until the stand is properly fitted.
(M4 x 12)
provided and tighten
x4
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way
when using the wall-hanging bracket or repacking
the TV.
• Put the TV onto a work table with the screen panel
down on the clean and soft cloth. Leave the stand(s)
protruding over the edge of the surface.
• Unsrew the screws that fixing the stand(s).
• Remove the stand(s).
When using the wall-hanging bracket
Please contact your local Panasonic dealer to
purchase the recommended wall-hanging bracket.
Holes for wall-hanging bracket installation;
Rear of the TV
a (mm)
b (mm)
View from the side
VESA
Bracket
c
Diameter
Depth of screw (c)
Depth of screw (c)
Diameter
Note: The screws for fixing the TV onto the wall-hanging
bracket are not supplied with the TV.
English - 4 -
a
b
43"
50"
55"
100
200
200
100
200
200
d
e
(d)
43"
50"
55"
M4
M6
min.
7 mm
max.
10 mm
(d)
min.
7 mm
max.
10 mm
65"
400
200
(e)
43"
50"
55"
M4
M6
5 mm
6 mm
(e)
65"
M6
Publicidad
