UFESA AE4829 valley Manual De Instrucciones página 24

Charge battery separately:
Plug the cable into the power inlet located on the top of the battery. When charging, the energy
indicator light will be illuminated Blue. Once fully charged this indicator light will keep bright in Blue.
Once fully charged, turn off the charger plug from the power socket.
Charge battery on the unit: When no power, three lights give a flickering light. While charging, the light
will become from one light to two lights, that means the battery is 50% charged. If the light illuminates
3 lights, that means 100% power.
The charging time is about 4-5hours.
NOTE:
1. In the event of a maintenance issue with the product such as a jammed brush roll, all three BLUE
indicator lights will flash on and off until the issue is resolved, in this case turn the cleaner off until the
issue is rectified.
2. Ensure that the air vent, floor brush and metal tube are free from blockages and dust. Should they
suddenly become clogged, switch off the appliance immediately and clear the blockage before
attempting to use the vacuum again.
3. Remove any sharp or large objects from the path of the vacuum before use as these may
irreparably damage the appliance.
Installation of electric floor brush, metal tube and handheld vacuum cleaner (Step 2)
NOTE: Before assembling the appliance fix the included wall-mounted storage base. Ensure it is placed
high enough for the vacuum to be securely mounted.
1. Install the battery into the housing by sliding it into the appropriate slot. It will
"click" into place.
2. Insert the connector of the floor power brush into the base of the metal tube by clicking it into place.
3. Attach the floor power brush and metal tube to the main body by slotting it into place via the air duct
connector.
4. If using the floor power brush without the tube, simply attach it to the main body via the air duct
connector. It will "click" when secure.
Attachment of accessories (Step 3)
1. Attach the metal tube to the main body by slotting it into place via the duct connector.
2. Attach the narrow crevice tool to the base of the metal tube via the connector. It will "click" into
place.
3. If using accessories without the tube, simply attach them to the main body via the air duct connector.
It will "click" when secure.
4. Attach the sofa nozzle to the metal tube or the main body, same as the narrow crevice tool.
Use sofa nozzle to vacuum fabric furnishings such as sofas, armchairs and curtains.
Use narrow crevice tool to vacuum narrow spaces such as corners and hard to reach areas.
24