Publicidad
Idiomas disponibles
Idiomas disponibles
1. Carefully unpack the appliance and remove all packaging materials.
2. Clean all removable parts in warm soapy water , and rinse well before
replacing.
3. Open the top lid, and pour drinking water into the water tank according to
the gauge.
Gauge : First step – 6 cups ; second step – 8 cups; third step – 10 cups; fourth
step – 12 cups (MAX).
4. For Drip Coffee Maker : Place the nylon filter into the funnel, making sure it
is assembled correctly, then close the top lid.
5. For Espresso Maker : Place the coffee filter into the filter holder (with no
coffee in the filter).
6. Attach the filter holder to the Espresso Maker by positioning it under the
boiler outlet with the handle towards the left so that the handle lines up
with the unlock icon
to the right until it lines up with the lock icon
7. Place carafe on warming plate and place a cup on the drip tray grid.
8. Plug in the appliance.
9. Press
ready indicating light stops flashing, the preheating is finished.
10. Press
the display.
•
Allow the water to run through the machine for about 30 seconds. Stop
the flow by pressing
•
NOTE: There may be some noise when water is pumped for the first
time. This is normal.
CBE18 IB OP JUN 1.indd 53
BEFORE FIRST USE
. Push filter holder upwards while sliding the handle
and the ready indicator light will flash on the display. When the
to begin delivering water. The espresso indicator light will flash on
.
.
53
13/6/2022 3:19 PM
Publicidad
