Publicidad
Idiomas disponibles
Idiomas disponibles
Regular cleaning of the pump may be necessary depending upon
the environment which it is operated. Clean the pump when it is
visibly soiled or when a drop in performance is detected.
Step 1. Before cleaning, always
disconnect the pump from the power
source and remove the inlet screen.
Step 2. Remove the impeller housing
to expose the impeller assembly.
Step 3. Remove the impeller
assembly by gently pulling on
the impeller blades. The impeller
is held in place by a magnet.
NOTE: This pump uses a very
strong magnet. To protect your
fingers from potential injury,
use caution when removing or
inserting the impeller.
Step 4. Use a soft cloth or brush and
warm water to clean the impeller and
the inside of the impeller and rotor
housing.
Step 5. Reassemble all pump
parts, place the pump inside the
pumpshield and place in water before
reconnecting to the power source.
IF THE PUMP FAILS TO OPERATE:
• Check to make sure the power cord is plugged in and the pump
is getting power.
• Check the pump outlet and any tubing, fountains, spitters etc.
for kinks or obstructions.
• Remove the inlet screen and/or pump cover, and impeller
housing to expose the impeller. Turn the impeller to ensure that
it is not broken or jammed. Also check to make sure that the
ceramic shaft or bearings are not broken.
IF THE PERFORMANCE OF THE PUMP IS NOT SATISFACTORY
OR THE PUMP DOES NOT FLOW EVENLY:
• Check to make sure the pump is completely submerged in water
• Check to make sure the impeller and the impeller housing are clean.
• Check to make sure the pumpshield is clean.
For product maintenance videos visit totalpond.com
8
PUMP
TROUBLESHOOTING
Visit WWW.TOTALPOND.COM for information and tips.
1
2
4
5
3
Publicidad
