Features; Operation Instructions; Maintenance - Urrea CM916 Manual De Usuario Y Garantía

AFTER CONNECTING THE POWER PLUG TO AN
APPROPRIATE AC POWER SOURCE, CHECK THE
OPERATION OF THE TOOL, AS FOLLOWS:
• Trial Run. After confirming that no one is
standing in front of it, step away from the
front position and start the power tool and
confirm that no operating abnormalities exist
before attempting a cutting operation. Trial
run periods:
When replacing the cut-off wheel; Over 3 min.
When starting routine work; Over 1 minute.
• Inspect the rotating stability of the cut-off
wheel. For precise cutting, rotate the cut-off
wheel and check for deflection to confirm that
the wheel is not noticeably unstable; otherwise
vibration might occur and cause an accident.

FEATURES

KNOW YOUR TOOL
Before attempting to use this chop saw, be-
come familiar with all of its operating features
and safety requirements.
6
5
1. HANDLE.
2. SAFETY GUARD.
3. CUTTING WHEEL.
4. VISE.
5. CLAMP SCREW HANDLE.
6. BASE.

OPERATION INSTRUCTIONS

PRACTICAL APPLICATIONS
WARNING: Never remove or install a work-
piece while the cut-off wheel is rotating to
avoid personal injury.
PROCEDURE TO PLACE THE CUTTING MATERIAL
Place the workpiece between the press of work
and the top of the fence, loosen the screw by
10
1
2
3
4
turning the knob. After placing the object to
be cut, turn the knob and thus tightly clamp
the workpiece.
After the cut-
ting work, turn
the handle of the
press 2 or 3 times
to loosen and re-
move the piece.
1. Turn ON the cut-off wheel, gently press
down the handle, and bring the cut-off wheel
close to the material to be cut.
2. When the cut-off wheel contacts the mate-
rial, gently press down the handle further and
start cutting.
3. When cutting (or designated slotting) is
completed, raise the handle and restore it to
its original position.
4. At the termination of each cutting process,
turn OFF the switch to stop rotation and pro-
ceed with the subsequent cutting job.
WARNING: Confirm that the trigger switch
is turned OFF and that the power plug has
been removed from the receptacle, whenever
the tool is not in use.
CAUTION: Increased pressure on the handle
will not increase the cutting speed. On the
contrary, too much pressure may result in over-
load of the motor and/or decreased cutting ef-
ficiency.
CUTTING WITH A REDUCED DISC
When the cut-off wheel has a reduced outer
diameter, insert between the vise (A) and (B) a
metallic block slightly smaller than the dimen-
sion of workpiece being cut to use the cut-off
wheel economically.

MAINTENANCE

REMOVAL / INSTALLATION OF WHEEL
TO REMOVE
• Unplug the cut-off machine.
• Remove motor chain from hook.
• Raise machine arm to its full raised posi-
tion. Be cautious when raising, machine arm is
spring loaded.
• Remove axe guard, exposing the hex head bolt
that secures abrasive wheel to wheel arbor.
• Depress the spindle lock button and rotate
bolt until spindle locks, preventing shaft from
rotating.