Axxess BX-CH3 Instrucciones De Instalación página 2

Applications
CHRYSLER
300 2005-2007
Aspen
PT Cruiser 2006-2010
DODGE
Caliber 2007-2008
Charger 2006-2007
Dakota 2005-2007
Durango 2004-2007
Magnum 2005-2007
IMPORTANT WARNING
This product includes instructions for an installation which must be care-
fully followed. The instructions are worded in such a manner as to assume
that the Installer is capable of completing this type of electronic installation.
If you are unclear as to what you are instructed to do, or believe that you
do not understand the instructions so as to properly and safely complete
the installation, then you should consult a technician who does have this
knowledge and understanding. Failure to follow these instructions carefully,
and to install the interface as described, could cause harm to the vehicle
or to the safety systems in the vehicle. Interference with certain safety
systems could cause harm to persons as well.
Ram 1500
Ram 2500/3500
2007 Ram Chassis Cab
JEEP
Commander
Compass
Grand Cherokee
Patriot
MITSUBISHI
Raider
BX-CH3
Connections to be made
2006-2008
Attention!
This interface will work with models that are either factory
2006-2009
amplified, or non-amplified. Please follow the instructions carefully for your
2006-2010
model vehicle. Failure to do so will result in either no sound, or low sound.
If you are unsure if your vehicle is factory amplified or not, please contact
2006-2007
your local Dealer.
2007-2008
2005-2007
From the 16-pin harness with stripped leads
2007-2008
to the aftermarket radio:
2006-2007
• Connect the (2) Red wires to the accessory wire.
• Connect the Blue/White wire to the amp turn on wire. (This wire must be
connected to hear sound from the factory amplifier.)
• Connect the Orange/White wire to the illumination wire. (If the aftermarket
radio has no illumination wire, tape off and disregard this wire.)
• Tape off and disregard the Brown wire, it will not be used in this application.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
2
Continued on the next page