RedMax HTZ750 Manual Del Usuario página 10

3. Hold the product near your body for a stable work
position.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
Maintenance schedule
Maintenance
Clean the external surface.
Clean the muffler, exhaust pipe and engine from leaves, dirt and unwanted lubri-
cant.
Make sure that the cutting attachment does not move at idle speed.
Do a check of the stop switch, refer to
6 .
Examine the cutting attachment and the cutting attachment guard for damages
and cracks. Replace if it is damaged.
Examine the hand guard for damages and cracks. Replace if it is damaged.
Do a check of the throttle trigger lockout and the throttle trigger, refer to
check of the throttle trigger lockout on page 5 .
Examine the engine, the fuel tank and the fuel lines for leaks.
Tighten nuts and screws.
Examine the fuel filter for contamination and the fuel hose for cracks and other
defects. Replace if necessary.
Examine the starter and the starter rope for damages.
Clean the air filter. Replace if it is necessary.
Examine the spark plug, refer to
Clean the cooling system.
10
4. Be careful and operate the product slowly.
Maintenance
To do a check of the stop switch on page
To examine the spark plug on page 11 .
Before After 40
operation h
After each operation.
After each operation.
X
X
X
X
To do a
X
X
X
X
X
X
X
X
1075 - 001 - 18.03.2019
After 100
h