RedMax HTZ750 Manual Del Usuario página 14

Blade
Problem
The blade moves slowly or
does not move.
The blade does not cut
easily.
The blade becomes hot.
Transportation, storage and disposal
Transportation and storage
• Always allow the product to cool down before
storage.
• For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from electrical
devices or boilers, can start a fire.
• Always use approved containers for storage and
transportation of fuel.
• Empty the fuel before transportation or before long-
term storage. Discard the fuel at an applicable
disposal location.
Technical data
Engine
Cylinder displacement, cu.in/cm
Idle speed, rpm
Recommended max speed, rpm
Maximum engine power acc. to ISO 8893, kW/hp @ rpm
Catalytic converter muffler
Ignition system
Spark plug
Electrode gap, inch/mm
Fuel
14
Possible causes
The blade is blocked or it is
damaged.
The blade is not sharp or it
is damaged.
There is friction between
the blades.
Technical data
3
Recommended step
Clean the blades from unwanted materials. Refer to
clean and lubricate the blades on page 12 . Remove
burrs from the blade, refer to
page 12 . Replace the blade if it is damaged.
To examine the blades on
Sharpen the blade, refer to
page 12 . Replace the blade if it is damaged.
Remove burrs from the blade and lubricate the blade.
To examine the blades on page 12 .
Refer to
• Attach the transport guard during transportation and
storage.
• Remove the spark plug cap from the spark plug.
• Attach the product during transportation. Make sure
that it cannot move.
• Clean and do servicing on the product before long-
term storage.
HTZ750
1.32/21.7
3000
9200
0.6/0.8 @ 7800
Yes
NGK CMR6A
0.02/0.5
To
To examine the blades on
1075 - 001 - 18.03.2019