Publicidad
Idiomas disponibles
Idiomas disponibles
3. APPLYING THE CUFF
a. Pulling the cuff end through the medal loop (the cuff is
packaged like this already), turn it outward (away from your
body) and tighten it and close the Velcro fastener.
b. Place the cuff around a bare arm 1-2cm above the elbow
joint.
c. While seated, place palm upside in front of you on a flat
surface such as a desk or table. Position the air tube in the
middle of your arm in line with your middle finger.
d. The cuff should fit comfortably, yet snugly around your
arm. You should be able to insert one finger between your arm and the cuff.
Note:
• Please refer to the cuff circumference range "SPECIFICATIONS" to make sure
that the appropriate cuff is used.
• Measure on the same arm each time.
• Do not move your arm, body, or the monitor and do not move the rubber tube
during measurement.
• Stay still, calm for 5 minutes before blood pressure measurement.
• Please keep the cuff clean. If the cuff becomes dirty, remove it from the
-15-
Publicidad
