AHT MONTREAL Serie Manual De Instrucciones página 21

en | AHT Cooling Systems GmbH
Units with push-back glass cover
Upper edge of device frame
Sealing lip
Fig. 5: Push-back glass cover (2-part)
Removing push-back glass cover (2-part)
– Use the handle to slide cover A all the way back except for a finger's width.
– Hold cover A at the handle and at the center in the back.
– Slightly lift cover A at the rear over the upper edge of the device frame, slide it back and lift it
out.
– Slightly light cover B and lift it out to the front.
Installing push-back glass cover (2-part)
– Insert cover B at the rear. Cover B must be under the cover lock.
The sealing lip of cover B is at the front top.
Cover B
Fig. 6: Cover lock
– Hold cover A at the handle and at the center in the back.
– Place cover A at the upper edge of the device frame at the rear and over cover B at the front.
– Use the handle to pull cover A along the guide to the front and close it.
Guide
Fig. 7: Guide
– Check for correct functioning.
397482_2_1018
B
A
Cover lock
Cover A
Cover lock
B
A
Guide
Device front
Setup and installation | 3
21 / 64