Descargar Imprimir esta página

Oster OGME1701 Manual De Instrucciones página 21

Horno microondas para cocina

Publicidad

Idiomas disponibles

Idiomas disponibles

I NSTALLATIO N GU I D E
Kitchen Installation
Remove all packing material and acces-
sories. Examine the oven door for any
damage such as dentures or broken door.
Do not install if the oven is damaged.
Installation
Select a surface level that provides
sufficient space for the extraction and
introduction fans.
1. A minimum clearance of 3.0 inches
(7.5cm) is required between the oven and
the adjacent walls. One side must be
open.
1. Leave a minimum of 12
inches (30cm) above the oven.
2. Do not remove legs under the
oven.
3.Blocking the extraction and/or
insertion openings may damage
the oven.
CO NNEC TION I NST R U CT ION S
This appliance must be grounded. In the event of an electrical short circuit, being grounded reduces the
risk of electrical shock by providing an escape wire for the electrical current. This application is equipped
with a cable with a grounding wire and a grounding connector. The connector must be connected to a
properly installed ground.
WARNING - Improper use of the ground connection may result in a risk of electric shock.
Cabinet: Remove any protective film
found in the microwave or on the surface
of the cabinet. Do not remove the light
brown Mica coating that is attached to the
oven cavity to protect the magnetron.
4. Place the oven as far away
from radios and televisions as
possible. Operating the micro
wave oven may cause interfer
ence with your radio or TV
receiver.
2. Plug your oven into a standard house-
hold outlet. Make sure that the voltage
and frequency are the same as the
voltage and frequency rating label.
WARNING: Do not install the oven over a
heat-producing application. Installing it
near or over a heat source may damage
the oven and void the warranty.
The accessible surface
may be hot during opera-
tion.
Eng lis h- 4
-

Publicidad

loading

Este manual también es adecuado para:

Ogme1702