Beko RCNA320K20PT Instrucciones Para El Uso página 11

EN
Electrical requirements
Before inserting the plug into the wall socket make
sure that the voltage and the frequency shown in
the rating plate inside the appliance corresponds
to your electricity supply.
We recommend that this appliance is connected to
the mains supply via a suitably switched and fused
socket in a readily accessible position.
Warning! This appliance must be earthed.
Repairs to electrical equipment should only be
performed by a qualified technician. Incorrect
repairs carried out by an unqualified person are
carry risks that may have critical consequences for
the user of the appliance.
ATTENTION!
This appliance operates with R600a which is an
environmental friendly but flammable gas. During
the transportation and fixing of the product, care
must be taken not to damage the cooling system.
If the cooling system is damaged and there is a
gas leakage from the system, keep the product
away from open flame sources and ventilate the
room for a while.
WARNING - Do not use mechanical devices or
other means to accelerate the defrosting process,
others than those recommended by the
manufacturer.
WARNING - Do not damage the refrigerant circuit.
WARNING - Do not use electrical appliances
inside the food storage compartments of the
appliance, unless they are of the type
recommended by the manufacturer.
WARNING - If the supply cord is damaged, it must
be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a
hazard.
Transportation instructions
1. The appliance should be transported only in an
upright position. The packing as supplied must be
intact during transportation.
2. If during the transport the appliance, has been
positioned horizontally, it must not be operated for
at least 4 hours, to allow the system to settle.
3. Failure to comply with the above instructions
could result in damage to the appliance, for which
the manufacturer will not be held liable.
4. The appliance must be protected against rain,
moisture and other atmospheric influences.
Important!
• Care must be taken while cleaning/carrying the
appliance not to touch the bottom of the
condenser metal wires at the back of the
appliance, as this could cause injury to fingers and
hands.
• Do not attempt to sit or stand on top of your
appliance as it is not designed for such use. You
could injure yourself or damage the appliance.
• Make sure that the mains cable is not caught
under the appliance during and after moving, as
this could damage the cable.
• Do not allow children to play with the appliance
or tamper with the controls.
Installation instructions
1. Do not keep your appliance in a room where the
temperature is likely to fall below -15 degrees C (5
degrees F) at night and/or especially in winter.
2. Do not place the appliance near cookers or
radiators or in direct sunlight, as this will cause
extra strain on the appliance's functions. If
installed next to a source of heat or freezer,
maintain the following minimum side clearances:
From Cookers 30 mm
From Radiators 300 mm
From Freezers 25 mm
3. Make sure that sufficient room is provided
around the appliance to ensure free air circulation
(Item 2).
• Put the back airing lid to the back of your
refrigerator to set the distance between the
refrigerator and the wall (Item 3).
4. The appliance should be positioned on a
smooth surface. The two front feet can be
adjusted as required.To ensure that your
appliance is standing upright adjust the two front
feet by turning clockwise or anti-clockwise, until
firm contact is secured with the floor. Correct
adjustment of feet prevents excessive vibration
and noise (Item 4).
5. Refer to "Cleaning and Care" section to prepare
your appliance for use.
2
Instruction for use