Publicidad
Idiomas disponibles
Idiomas disponibles
• Make sure that the cord is not hanging over the edge of the table
or counter, does not touch any hot surfaces or is coming directly
into contact with the hot parts of theappliance. Do not place the
appliance underneath or close to curtains, window coverings etc.
(*) Competent qualified electrician: after sales department of the
producer or importer or any person who is qualified, approved
and competent to perform this kind of repairs in order to avoid
all danger. In any case you should return the appliance to this
electrician.
PARTS DECRIPTION
1
2
3
4
5
9
PARTS FAN
1. Front guard
2. Fan blade lock button
3. Fan blades
4. Locknut for the rear guard
5. Rear guard
4
6
8
7
10
11
12
13
6. Axle
7. Motor front cover
8. Oscillation pen
PARTS STAND
9. Clip
10. Speed control knobs
11. Knob for height adjustment
12. Base cover
13. Stand feet
BEFORE USE
• Take the appliance and accessories out the box. Remove the
stickers, protective foil or plastic from the device.
• Connect the power cable to the socket. (Note: Make sure the
voltage which is indicated on the device matches the local voltage
before connecting the device. Voltage 220V-240V 50Hz).
MOUNTING
Note: when you don't have a stand fan you have to skip the first two
points and start at point 3.
1. Loosen and remove the four screws from the bars, cross the bars
place the extension pipe on the feet and fasten the screws again.
2. Loosen the screw on the housing by turning it to the left and place
the housing on the extension pipe and fasten the screw again.
3. Mount the rear guard to the motor by matching the holes on the
rear guard to the round pins on the motor housing. Put the guard
over the pins.
Publicidad
