Publicidad
Idiomas disponibles
Idiomas disponibles
Applications
CHRYSLER
Grand Caravan 2008-up
200
2011-2014
Journey
300
2008-2010
Magnum
Aspen
2008-2009
Nitro
Sebring
2007-2010
Ram 1500
Town & Country 2008-up
Ram 2500/3500
DODGE
Avenger
2008-2014
Ram Chassis Cab
JEEP
Caliber
2009-2012
Challenger
2008-2014
Commander 2008-2010
Charger
2008-2010
Compass
Dakota
2008-2011
Grand Cherokee
Durango
2008-2013
IMPORTANT WARNING
This product includes instructions for an installation which must be care-
fully followed. The instructions are worded in such a manner as to assume
that the Installer is capable of completing this type of electronic installation.
If you are unclear as to what you are instructed to do, or believe that you
do not understand the instructions so as to properly and safely complete
the installation, then you should consult a technician who does have this
knowledge and understanding. Failure to follow these instructions carefully,
and to install the interface as described, could cause harm to the vehicle
or to the safety systems in the vehicle. Interference with certain safety
systems could cause harm to persons as well.
Liberty
2008-2012
2009-2010
Patriot
2009-up
2008-2009
Wrangler
2007-up
2007-2011
Wrangler Unlimited
2009-2011
2007-up
MITSUBISHI
2010-2011
Raider
2008-2009
RAM
2011
1500/2500/3500
Chassis Cab
2009-up
C/V Tradesman 2012-up
Routan
2009-2013
2008-2013
BX-CH4
Connections to be made
Attention!
This interface will work with models that are either factory
amplified, or non-amplified. Please follow the instructions carefully for your
model vehicle. Failure to do so will result in either no sound, or low sound.
If you are unsure if your vehicle is factory amplified or not, please contact
your local Dealer.
From the 16-pin harness with stripped leads
to the aftermarket radio:
2012
2012
• Connect the (2) Red wires to the accessory wire.
• Connect the Blue/White wire to the amp turn on wire. (This wire must be
connected to hear sound from the factory amplifier.)
• Connect the Orange/White wire to the illumination wire. (If the aftermarket
radio has no illumination wire, tape off and disregard this wire.)
• Tape off and disregard the Brown wire, it will not be used in this application.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
2
Continued on the next page
Publicidad
