Publicidad
Idiomas disponibles
Idiomas disponibles
Note
When carrying, the lens hood can be attached in the
0
reverse direction.
1
Align mark B (
on the tip of the lens.
2
Attach the lens hood by rotating it in the direction of
the arrow until it clicks.
It is recommended to remove the lens hood during
0
flash photography as the lens hood can block the light
from the flash.
To prevent dropping of the lens, you should never carry
0
the lens by just holding the lens hood.
∫ Notes on filter use
It is possible to attach the lens cap or the lens hood
0
with the filter already attached.
There may be some vignetting in recorded images if
0
multiple filters are attached simultaneously.
It is not possible to attach any items other than filters
0
such as a conversion lens or adaptor to the front of the
lens and use it in combination with this lens.
Lens damage may result if such items are attached.
22
DVQX2166
(ENG)
) on the lens hood with the mark
Switching AF/MF
Switch AF/MF by sliding the
focus ring A forwards or
backwards (focus clutch
mechanism).
When the digital camera is
0
set to MF, the operation will
be MF irrespective of the
position of the focus ring.
Check the distance scale B
0
when using MF. Use it as a
guide for focusing.
You can set the amount of
0
movement for focusing using
the focus ring with the menus
in compatible digital cameras.
Switch the lens to AF and set
the digital camera to MF. Refer to the operating
instructions for the digital camera for details.
AF
MF
1. 1
1.3
1.8
2.5
5
15
feet
0. 1
0.4
0.5
0.7
1.5
4
m
Publicidad
