Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION PROCEDURE - TBW01016U
Slide Bar
1) For tile or concrete wall installation, drill 1/4" holes against the included paper template (not
shown) for insertion of wall anchors. For installation directly to a wooden stud or stinger, drill
(1/8"-5/32") pilot holes . Anchors should not be used if attaching to a wall stud.
NOTE: Reinforce when mounting on a hollow wall.
NOTE: Escutcheon (with "TOTO" marking) is installed on the lower base bracket. Make sure the
bracket post hole is in the vertical direction.
the wall with tapping screws then put the Escutcheon on the base bracket.
3) Fix the lower base bracket properly by the same method.
Set Screw (having been
slide bar
Bracket Post
6
Bracket Base
Bracket Post
Wall Anchor
Escutcheon
Escutcheon
Publicidad
