Metra 95-HDIF-NP Manual De Instrucciones página 4

9. Remove (1) T25 Torx screw and washer
from each side of the switch panel. Turn
the forks to the left, slightly pull the
panel out to gain access underneath,
then unplug the switch panel connector.
Remove the switch panel.
Note: If the forks lock, insert a flat-blade
screwdriver into the ignition switch hole.
There will be a notch cut-out inside.
Slightly turn to the right to unlock
the forks.
10. Remove (2) Torx screws securing each
turn signal, then remove the turn signal
and front chrome trim. (Figure H)
4
FAIRING DISASSEMBLY
(Figure H)
(Figure I)
(CONT.)
11. Remove the clutch cable.
a. Loosen up the clutch lever:
Slide the rubber boot up from
the clutch adjustment cable, then
using a 9/16" and 1/2" open ended
wrench, break the locking nut free.
Screw the adjustment nut in to
provide slack in the clutch lever.
(Figure I)
b. Remove the snap ring from the pivot
pin under the clutch lever, then pull
the pin out. (Figure J)
c. Remove (2) T27 Torx screws and
washers securing the clutch lever
to the clutch bracket, then remove
the lever. (Figure K)
d. Pull the anchor pin out from the
clutch cable. (Figure L)
e. Pull the clutch cable thru the fairing,
just enough to clear the fairing.
Continued on the next page
(Figure J)
(Figure K)
(Figure L)
|
1.800.221.0932 MetraOnline.com