Metra 95-HDIF-NP Manual De Instrucciones página 5

12. Unplug the cigarette lighter, then
remove it by unscrewing the outer cover
which is inside the fairing. Keep your
fingers in the cigarette lighter to prohibit
it from spinning.
13. Remove (2) T25 Torx screws securing the
speakers, then unplug and remove
the speakers.
14. Unscrew the rubber boot from the reset
switch, then remove the switch.
(Figure M)
15. Unplug the speedometer and tach
gauges. Remove (2) screws securing the
black plastic brackets to each gauge
(4 in total), then remove the gauges
from the back. (Figure N)
FAIRING DISASSEMBLY
(Figure M)
(Figure N)
(CONT.)
16. Unplug but do not remove the
remaining gauges. They will be removed
at the bench.
17. Carefully pry outwards on the bottom
of the fairing to release the fairing and
fairing lower bracket from the dowel
pins in the forks. (Figure O)
18. Lift the fairing slightly up to gain access
to the fairing lower bracket, then grab
and remove the bracket from the fairing.
The fairing should be completely free at
this point. Have patience in this step as
the fairing will most likely get caught
up being removed. Take the fairing
to the bench for further removal of
components.
Continue to Kit Preparation
(Figure O)
REV. 6/2/2020 INST95-HDIF-NP
5