Ludocris SOUL SL300 Manual De Instrucciones página 8

Installing the Batteries and Selecting the Hi/Lo Output
Please take the two AAA batteries included with your accessories and remove the protective plastic shrink wrap. On the right side of
your headphones is the battery compartment. Place your thumbs as illustrated in the diagram below on both sides of the battery door
(Logo Plate). You will notice two dimples opposite of each other as a guide. Gently press down on the battery door and turn to the left
(counter-clockwise) about 1/8". At this point the battery door should be loose. Install your batteries following the positive
+ and negtive - symbols. Before replacing the battery cover you will notice a slide switch (see illustration below) labeled Hi
and Lo. The switch should be pre-set to the Hi position. If the device you are using has unusually high output you can change the switch
to Lo. This will lower the overall sound level output of your headphones. Replace the battery cover and turn gently to the right
(clockwise) until the battery cover locks in place.
6