Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning the heater
1. Turn off and unplug the heater. Then let it cool down completely.
2. Use a damp cloth to wipe off any dirt or smudges.
Do not let water touch the control panel
vents
.
3
3. Let all parts dry completely.
4. Use a vacuum cleaner or compressed air to keep the heating element and
air vents free of dust and dirt.
Replacing the chandelier lightbulbs
WARNING!
Risk of fire!
Handling the heater improperly may cause a fire and pose a
risk of injury or risk to life.
− Only use 120 V bulbs no greater than 40 W each.
− Use of a higher rated bulb may result in a fire, causing
damage to property, personal injury or loss of life.
You will need a cross-head screwdriver in order to change the
lightbulbs. For convenience, if one lightbulb burns out, it may be
easier to replace both at the same time.
To change the chandelier lightbulbs, proceed as follows:
1. Turn off the heater and unplug it from the electrical outlet.
2. Let the heater cool down if it has been in use.
3. Turn the heater around so you are facing the back.
The chandelier lightbulbs
4. Remove the two cross-head screws
5. Lift the access panel so the two positioning tabs come out of their slots, and
then remove it.
6. Unscrew each chandelier lightbulb by turning it counterclockwise out of
their bases.
7. Screw in each new chandelier lightbulb by turning it clockwise into their
bases.
4
12
are located behind the access panel
from the access panel (see fig. D).
11
Cleaning and maintenance
or heating element and air
5
.
15
Publicidad
Capítulos
Tabla de contenido
