Authorized KICKER Dealer:
Purchase Date:
Speaker Model Number:
Speaker Serial Number:
WARNING: KICKER products are capable of producing sound levels that can permanently damage your
hearing! Turning up a system to a level that has audible distortion is more damaging to your ears than
listening to an undistorted system at the same volume level. The threshold of pain is always an indicator
that the sound level is too loud and may permanently damage your hearing. Please use common sense
when controlling volume.
SPECIFICATIONS
Model
Rated Impedance [Ω]
Fs [Hz]
Continuous Power Handling [Watts RMS] 450
Sensitivity [1W, 1m]
Xmax (Linear Excursion) [mm]
Re [Ω]
Qms
Qes
Qts
Vas [ft³, L]
Outer Frame Dimension [in, cm]
Mounting Cutout [in, cm]
Mounting Depth [in, cm]
Frequency Response [Hz]
Note: All specifi cations and performance fi gures are subject to change. Please visit www.kicker.com for the most
current information. To get the best performance from your new KICKER Subwoofer, we recommend using genuine KICKER
Accessories and Wiring. Please allow two weeks of break-in time for the subwoofer to reach optimum performance.
WIRING
Solo-Baric L7 subwoofers are available with dual 2Ω (ohm) or dual 4Ω voice coils. Both coils must be
connected to a source of amplifi cation. The dual 2Ω woofer will generate a 1Ω load if the coils are wired in
parallel or a 4Ω load in series. The dual 4Ω woofer will provide a 2Ω load wired in parallel or 8Ω load wired
in series. The terminals with the white dots are for the fi rst voice coil. The terminals with solid-red and
solid-black markings are for the second voice coil. See Figure 1.
Sound Check: Poor bass response? Check the system phasing by reversing the positive and negative
speaker connections on the subwoofer. If the bass improves, then the subwoofer was out of phase in
reference to the rest of the audio system.
2
2017 L7 Rev F.indd 2
2017 L7 Rev F.indd 2
SOLO-BARIC L7 SUBWOOFER
OWNER'S MANUAL
Models:
L7S8 / L7S10 / L7S12 / L7S15
L7S8
2 or 4
47.2
82.37
.52 (13.5)
6.6
8.828
.802
.735
.322 (9.127)
8-3/16 (22.4)
7-1/4 (18.4)
4-3/4 (12.1)
28–500
L7S10
L7S12
2 or 4
2 or 4
37.5
34
600
750
85.87
86.90
.64 (16.25)
.64 (16.25)
7.9
6.8
9.791
9.488
.535
.571
.507
.539
1.0 (28.347)
1.916 (54.274)
10-11/16 (27.1) 12-5/8 (32)
9-5/16 (23.7)
11-1/16 (28.1)
6-1/4 (15.9)
6 13/16 (17.3)
24–500
20–500
L7S15
2 or 4
26.3
1000
88.56
.75 (19)
7.0
11.868
.565
.539
5.263 (149.048)
15-5/8 (39.7)
13-3/4 (34.9)
8 11/16 (22.1)
18–500
11/1/2016 4:13:30 PM
11/1/2016 4:13:30 PM