GreenWorks GPW1501 Manual Del Operador página 9

4.5 START THE MACHINE
CAUTION
Do not operate without the water supply connected.
CAUTION
Before you start the machine:
1. Turn the water supply on.
2. Pull the gun trigger to release air pressure.
3. If a stable stream of water comes out from the gun,
release the gun trigger.
1. Connect the machine to the power supply.
2. Set the power switch to the "ON" ( | ) position.
3. Turn the water supply on.
4. Pull the gun trigger.
4.6 STOP THE MACHINE
1. Release the spray gun trigger.
2. Press down on the ON/OFF switch, once again, to set the
power switch to the "OFF" (O) position.
WARNING
If you do not use the machine：
• Stop the machine.
• Turn the water supply off.
• Disconnect the power cord from the outlet.
• Pull the spray gun trigger to release the remaining
pressure from the machine.
• Engage the trigger safety lock-out on the spray gun.
English
5
Before maintenance, make sure that you
•
•
•
14
Do not use strong solvents or detergents on the plastic
housing or components.
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Replace the power cord by an approved service center.
5.1
If there is too much pump pressure, the nozzle can become
clogged, you can feel a pulsing sensation while you pull the
gun trigger.
5.1.1
1. Pull back the quick-connect collar on the gun wand.
2. Remove the nozzle from the gun wand.
5.1.2
1. Use a straight paper clip or cleaning tool to clean the
spray tip.
2. Flush and clean the unwanted materials out of the nozzle
with the garden hose.
3. Install the clean nozzle to the spray wand.
6
Disconnect the power cord and watter supply hose before
transportation and storage.
9
MAINTENANCE
WARNING
Stop the machine.
Wait until all the moving parts stop.
Disconnect the plug from the power source.
WARNING
WARNING
WARNING
NOZZLE MAINTENANCE
REMOVE THE NOZZLE
CLEAN THE NOZZLE
TRANSPORTATION AND
STORAGE
WARNING
EN
11
5