MoMi LIMURU Manual De Instrucciones página 9

shown at picture 19b).
ADJUSTMENT OF CUSHIONING:
This stroller has a two-stage shock absorption adjustment (as shown at picture 20-21). The adjusting
levers are located on the underside of the brake rear axle just below the springs (as shown at picture
21). When driving on uneven surfaces, pull the lever firmly towards the rear axle until it locks. In this
position, the shock absorbers will smooth out any unevenness. When riding on a flat surface, firmly pull
the button in the opposite direction until it locks and the spring visibly tightens. In this position, the shock
absorbers will provide greater stability.
INSTRUCTIONS FOR USE OF THE SEAT BELTS:
The product is equipped with 5-point seat belts. In order to fasten the safety belts place both shoulder
straps buckles in the crotch strap buckle. Press down and make sure that they are properly fastened (as
shown at picture 22).
To unfasten the seat belts, press the button on the crotch strap buckle (as shown at picture 23).
The straps can be adjusted (as shown at picture 22) to fit your child properly, but be careful so that the
baby is not too tightly compressed and can breathe freely. When fastening a seat belt, pay attention that
the child's hands are not near the buckle.
Fasten all belts with a buckle and cover with a mattress.
Always use a clasp system.
Straps Removal (for cleaning): Remove the shoulder straps, lap straps and crotch straps from the holes
by pushing the plastic hooks inwards. Assembly is the reverse way. After assembly, make sure that the
plastic hooks securely block the straps.
ASSEMBLY AND ADJUSTMENT OF THE CANOPY:
To install the canopy, zip it around the inside of the carrycot. Tighten the clasps of the visor on the frame
so that the pins go into the holes. The canopy has the option of increasing the coverage area of the
gondola and the seat. To do this, open the lock on the outside of the roof (as shown at picture 24-25).
ASSEMBLY OF THE LEG COVER:
Attach the foot cover using the zipper on the inside of the seat. Close the zipper and close the Velcro
cover on the safety bar.
ADJUSTING THE HEIGHT OF THE SEAT BELTS:
The straps of the safety belts have a 3-step height adjustment to better adapt them to the child's needs.
To change the height, unclip the buckle by sliding it from the bottom of the backrest with one hand and
pull it out on the other side. Select the height at which you want to mount the belts, and then pass the
buckle through the hole in the fabric and pull it through the backrest until it locks on its back.
EN 9