MoMi URSO Manual De Instrucciones página 22

1. Headrest
2. Seat Cover
3. Shoulder Pads
4. Shoulder Straps
5. Harness Buckle
6. Crotch Pad
7. Adjustment Button
8. Adjustment Strap
9. Recline Handle
10. Shift Handle A
11. Belt Guidance A
12. Seat Reducer
13. Belt Guidance B
14. Shift Handle B
15. Base
16. Headrest Height Adjuster
17. Shoulder Pads Connector
18. Manual Back Cover
19. Top Tether Adjuster
20. Top Tether Clip
21. ISOFIX Locking Arms
22. (SIPS)
23. ISOFIX Buttons
24. Buckle Tongues
25. Red Release Button
26. Cover assembly tool
1. ISOFIX ATTACHMENTS
1.1 Find ISOFIX attachments between the base and the backrest - refer to your car's owner's
manual.
1.2 Press the button releasing the lock and take the ISOFIX forward as far as possible.
1.3 Press ISOFIX attachments into to ISOFIX attachments point. You will hear a loud click and you
will see a green symbol on the ISOFIX button when the lock is active. Repeat the other side.
1.4 The car seat should be located as close to the backrest of a seat of a car as possible. Grab the
seat to make sure that it is correctly attached.
ATTENTION: Make sure that the ISOFIX lock on both sides is marked as active.
ATTENTION: If the car seat does not cling to the seat and ISOFIX attachments are taken out of their
guides, the steps above have to be repeated.
1.5. To release the ISOFIX attachments press and hold a green button, which appears after a
correct mounting of a car seat. Press the button releasing the attachments and then pull the
car seat to hide the ISOFIX attachment in the base of the car seat.
2. CHANGE THE ORIENTATION AND ANGLE OF THE SEAT
Change from forward-facing to rear-facing seat position:
2.1 Pull the hand tilt adjustment handle (9) with one hand while pulling the lever (10), which is
located in the base of the car seat, with the other hand. At the same time hold the lever with
both hands, and take out the car seat from the base (15).
2.2 Turn the car seat and hold the tilt adjustment handle (9) mount the car seat to the guides
22 EN