MoMi URSO Manual De Instrucciones página 23

located in the base of the car seat (15).
2.2.1This position is suitable for groups 40-87cm (from 15 months of life). The car seat, which is
situated rear-facing is always set to the 5th seat tilt position.
Changing the position of a car seat from rear-facing to forward-facing:
2.3 Pull the adjustment handle (9) with one hand and the disassembly lever (10), located in the
base of the car seat, with the other hand. Simultaneously, hold both levers and take out the
car seat from the base (15).
2.4 Turn the car seat while holding the tilt adjustment handle (9), and mount it in the guides
located in the base of the car seat (15).
2.5 In the forward-facing position, the seat has 4 recline positions. The tilt of the seat can be
adjusted by pulling the adjustment handle (9).
Group 76-105cm: four recline positions can be used.
Group 100-150cm: use only the first position.
3. BELT AND HEADREST ADJUSTMENT
3.1 To loosen the straps, push the central strap adjustment button, which is located in the centre
of the seat (7). While pressing the button, pull on the straps to lengthen them.
3.2 Press the red button in the 5-point clasp (25), to unbuckle them.
3.3 Join the clasps of the chest straps (24) and then join it with the man clasp of the 5-point
safety belt. When all the belts are connected, you will hear a click indicating that the belts are
securely fastened.
3.4 To adjust the height of the headrest, unbuckle the 5-point safety belts and pull the headrest
adjustment handle (16) upward, hold it in that position and then adjust the headrest by mo-
ving it up or down as needed.
3.5 Adjust the strap length so that the right and left straps are the same lengths.
3.6 While pressing the central belt adjustment button, pull the strap (8) located next to the
button. The straps should fit tightly, but without compromising the child's comfort. Do not put
thick clothing (especially jackets) on the child, as it makes it difficult for the belts to fit snugly,
which can pose a danger to the child.
ATTENTION! Make sure that the safety belts fit tightly on the child's body. Safety belts that are too tight
or too loose can pose a danger to the child.
ATTENTION! WHEN A CHILD REACHES A HEIGHT OF 100CM, THE HARNESS STRAPS OF THE CAR SEAT
MUST BE REMOVED AND THE CHILD MUST BE FASTENED WITH A 3-POINT CAR SAFETY BELT.
4. REMOVING THE SEAT HARNESS STRAPS
4.1 Unfasten the 5-point buckle by pressing the red button (25). Remove the reduction insert (12)
and the belt buckle cover (6).
4.2 Loosen the shoulder straps (4), then remove the shoulder pad straps from the belt connector
(19), located at the back of the backrest.
4.3 Remove the shoulder pads (3) from the straps by undoing the Velcro.
4.4 Lift the upper part and unzip the lower part of the cover (2). Store the buckle (25) in the
compartment located in the seat, and hide the shoulder straps (5) behind the cover. Fasten
the lower part and lower the upper part of the cover.
ATTENTION! Do not use the reduction insert if the child's height is above 75cm.
ATTENTION! Before starting a car trip make sure that:
• ISOFIX attachment is mounted correctly and both ISOFIX indicators are green, which means that
the lock is activated.
EN
23