Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
1. After unpacking, wipe cooler with soft cloth.
2. Place the machine on a hard, flat surface, making certain the unit is level. The unit should not be placed
near direct sunlight or any other source of heat.
3. It is best to place the water cooler in an area with good air circulation. Make sure there is at least
4 inches (10cm) of space between the back of your water cooler and the wall. Keep a minimum distance
of 2 inches (5cm) on each side of your water cooler.
WARNING: The drain cap on the back of the unit may become loosened during shipping. Fasten the drain
cap tightly before starting the unit. A loose drain cap make leak causing floor damage.
IMPORTANT: Do not plug in the power cord yet.
4. Clean the top of the water bottle cap and neck with a clean cloth. Remove the tamper seal from
the plastic cap.
5. Invert bottle and line the center of the bottle cap over the probe of the no-spill device. Carefully push
bottle onto waterguard.
6. Place a cup under the hot faucet, and activate until water flows freely from the hot faucet. Repeat on the
cold side. Once water flows freely from both fuacets, the unit can be plugged in. Failure to follow these
steps may damage the water cooler and will void all warranty.
7. Plug the cooler into a grounded GFCI power outlet.
8. Flip the switch on the back of the unit to the ON position. The cooling and heating indicator lights on the
front of the unit will light up.
NOTE: Initial Rinsing of Waterways
During shipment, dust and odors can accumulate in the water cooler. It is recommended to flush a half-
gallon of water from both hot and cold faucets prior to use.
OPERATING YOUR WATER COOLER
Hot Water Temperature
Time Switch Icon
Heating Status Icon
4
All manuals and user guides at all-guides.com
Display Diagram
Hot Icon
F
Display Panel Buttons
oasiscoolers.com
Cold Water Temperature
F
Clock
Cold Icon
Cooling Status Icon
Publicidad
