Manuales relacionados para Samuel Heath V7K43-1LF
Resumen de contenidos para Samuel Heath V7K43-1LF
- Página 1 Product Data Sheet V743 3 Hole Bath / Tub Filler, Wall Mounted - Available Options - V7K43-1LF V7K43-1LK V7K43-2LF V7K43-2LK...
- Página 2 Dimension Key V743-K...
- Página 3 Dimension Key V743-F...
- Página 4 Flow Rates The flow rate data provided in this document is indicative of each product and is given in an open outlet condition. Installation design, external connections and fittings not supplied may affect the data provided.
- Página 5 Spares Information Item Part No. Description Item Part No. Description Screw Aerator Washer Spout Lever Diverter Knob Locknut VS56081 Diverter Cartridge Collar Grub Screw Spline Nut Handset Holder Escutcheon Screws Locking Collar Wall Plugs O-Ring Plate VS56037 Cartridge...
- Página 6 Installation 1. Remove blanking plugs (A) & (B).
- Página 7 Installation 2. Insert cartridge (C) into installation kit, ensuring locator peg on cartridge (C) slots into peg hole on the installation kit. 3. Secure cartridge (C) into the installation kit using locking collar. Note: Locking collar (D) must be tightened down to 10Nm, undone slightly, then re-tightened to 6.5Nm.
- Página 8 Installation 4. Apply silicone sealant to the finished surface before assembling backplate (E). 5. Push backplate (E) over locking collar (F) and against the finished surface as shown. 6. Align backplate (E) and secure them in place...
- Página 9 Installation 7. Push spout tail (G) through backplate (E) and screw into the installation kit behind the wall using a spanner (Not Provided). 8. Push spout assembly (H) onto spout tail (G), align to the desired angle and secure it to spout tail (G) using set screw (I). 9.
- Página 10 Installation 11. Push escutcheon cover (P) onto locking collar (N) to conceal flats 12. Push rotating collar (Q) onto locking collar (N), this will require force in order for it to snap into place. 13. Push lever head (R) through rotating collar (Q) and onto the spline on cartridge. 14.
- Página 11 Installation 15. Push lever (T) onto the taper of lever head (R). 16. Place anti-rotational washer (U) inside lever (T) and then secure lever (T) to lever head (R) using screw (V). Note: Do not discard anti-rotational washer (U) 17. Push indice cap (W) into lever (T) to conceal screw (V).
- Página 12 5. Ceramic cartridges in hard water areas. To prolong the lifespan and reduce servicing periods of your Samuel Heath tap we recommend that a suitable water softener be fitted. Consult your installer/designer for details.