Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
Water flows on the floor.
Temperature cannot be set.
The temperature in the ap-
pliance is too low/too high.
Power indicator light flashes. An error has occurred in
Possible cause
Appliance is fully loaded and
is set to the lowest tempera-
ture.
Temperature set in the ap-
pliance is too low and the
ambient temperature is too
high.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The "Frostmatic function" is
switched on.
The temperature is not set
correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
The Frostmatic function is
switched on.
There is no cold air circula-
tion in the appliance.
measuring the temperature.
ENGLISH
Solution
Set a higher temperature.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Attach the melting water
outlet to the evaporative
tray.
Switch off "Frostmatic func-
tion" manually, or wait until
the function deactivates au-
tomatically to set the tem-
perature. Refer to "Frost-
matic function" section.
Set a higher/lower tempera-
ture.
Refer to "Closing the door"
section.
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Refer to "Frostmatic func-
tion" section.
Make sure that there is cold
air circulation in the appli-
ance. Refer to "Hints and
Tips" chapter.
Contact a qualified electri-
cian or the nearest Author-
ized Service Centre.
15
Publicidad
