Publicidad
Idiomas disponibles
Idiomas disponibles
UNIT OVERVIEW & FEATURES
•
Compact Refrigerator
•
1.7 Cu. Ft.
•
Slide Out Wire Shelf
•
Chiller Compartment
•
Adjustable Mechanical Control
•
Adjustable Feet
•
Reversible Door
•
Energy Star Rating
•
Eco-Friendly R600a Refrigerant
UNIT DIAGRAM
DOOR CLOSED
1. Top Hinge
2. Handle
3. Refrigerator Door
4. Leveling Feet
DOOR OPEN
1
2
3
4
5
1. Thermostat Control Knob
2. Chiller Compartment
3. Wire Shelf
4. Drip Tray
5. Refrigerator Compartment
6. Bottle Storage
7. Door Gasket
O FF
6
OFF
7
OPERATION
Note: The chiller compartment has a temperature range of 30°F
to 48°F (in a room with a temperature of 77°F (25°C)). Ice cream
and Popsicles should be kept cool at -5°F to 0°F, hence this
chiller compartment is not suitable to store these types of items.
The thermostat control knob for the refrigerator and chiller is
located next to the chiller compartment.
The first time you turn the unit on, adjust the thermostat control
knob to "3" and give your refrigerator time to cool down com-
pletely before adding food; a full 24
hours is recommended.
After it is fully cooled, test it and ad-
just towards "1" to make less cool or
towards "6" to cool more to best suit
your needs. However, the setting of
"3" should be appropriate for home
or office refrigerator use.
NOTE: Turning the thermostat con-
trol knob to the "OFF" position will
stop the cooling cycle but does not
shut off the power to the unit.
DEFROSTING
Your refrigerator requires manual defrosting. You should defrost
your refrigerator in the following scenario:
•
You're not going to use it for an extended period of time.
•
You notice excessive ice built-up around the chiller.
It's also a good idea to defrost occasionally in any event.
To Defrost:
•
Turn the thermostat knob to the "OFF" position and
leave the door open.
•
Unplug the unit.
•
Remove all food from both
compartments.
•
Place a towel or two under
the refrigerator to collect the
water from the melting frost.
•
Leave open until all the frost
is melted. (Usually a num-
ber of hours or overnight will
suffice.)
•
Clean and wipe out the in-
terior of the unit with soapy
water and a non-abrasive cloth.
CLEANING & CARING FOR YOUR APPLIANCE
A clean, damp cloth with mild detergent or water and baking
soda should be used to clean the interior of the unit, after it is
defrosted or before use.
Go over once more with a damp cloth (sans soap) to ensure
there is no residue left inside after cleaning. Clean the gasket
carefully as well for best performance.
–5–
O FF
O FF
O FF
Publicidad
