babymoov Hygro Instrucciones De Uso página 8

• Warning: Micro-organisms that may
be present in the water or in the
environment where the appliance
is used or stored, can grow in the
water reservoir and be blown in the
air causing very serious health risks
when the water is not renewed and
the tank is not cleaned properly
every 3 days.
- Rated AC voltage: 220 V – 240 V / 50 Hz
- Vaporisation flow rate: 250 ml/hour at maximum output
- Power: 30 W
- Capacity of the water reservoir: 1.8 l
a. Air output
b. Water capacity
c. Water level sensor
d. Transducer
e. Base
f. Vapour flow adjustment
Please read these instructions carefully before switching the humidifier on. Please install the humidifier on a flat surface
well out of the reach of children.
Fill the water reservoir
1. Remove the reservoir from the humidifier base (diagram 1). Turn the water reservoir upside down.
2. Unscrew the filling plug (diagram 2).
3. Fill the water reservoir with tap water or distilled water (diagram 3).
4. Screw the filling plug in firmly (diagram 4).
5. Refit the reservoir on the main casing (diagram 5). Wait a few seconds for the humidifier base to fill with water.
Using the humidifier
6. Connect the supply lead to the mains (diagram 6). Turn the setting button to MAX .
Adjust the humidifier intensity to the desired setting:
- OFF = low intensity,
- MAX = high intensity.
Make sure that the vapour output is not facing walls, sockets or furniture.
Emptying the humidifier
7. Switch the humidifier off by turning to OFF and unplugging the appliance (diagram 7). The indicator light must be off. Disconnect
the appliance, remove the water reservoir from its base.
8. Empty the water from the base (diagram 8). Next, wipe off any remaining drops with a soft cloth.
If the humidifier does not work, you should check that:
- the lead is connected to the power socket,
- the vapour intensity control switch is working,
- the water reservoir has been replaced correctly on the base,
- there is sufficient water in the reservoir.
8
• Electric equipment is subject to a
TECHNICAL CHARACTERISTICS
COMPOSITION
g. Minimum humidity setting
h. Filling plug
i. Water reservoir
j. Emptying tube
k. Air output
INSTRUCTIONS
HYGRO • Instructions for use
selective collection procedure. Do not
throw away electrical and electronic
equipment waste with the unsorted
municipal refuse, but carry out a
selective collection.
Throughout the European Union
this symbol indicates this
product must not be thrown in
the dustbin or mixed with
domestic waste but undergo
selective collection.