Ryobi RBC38SB Manual De Utilización página 23

GB
F D E
SPECIFICATIONS
Engine displacement
Maximum engine performance
(in accordance with ISO 8893)
Maximum rotational frequency
of the the spindle
Engine speed (rotational frequency)
at recommended max. spindle
rotational frequency
Engine speed (rotational frequency)
at idle
Fuel consumption (in accordance
with ISO 8893) at max.
engine performance
Specific fuel consumption
(in accordance with ISO 8893)
at max. engine performance
Vibration level idling
- Left handle
- Right handle
Vibration level racing
- Left handle
- Right handle
Sound pressure level
(in accordance with EN ISO 11806:
1997, ISO 7917:1987)
Sound power level
(in accordance with ISO 10884)
DESCRIPTION
1. M6 wrench
2. Hole of the gear case
3. Hole in the upper flange washer
4. Upper flange washer
5. Blade cover
6. Blade
7. Cupped washer
8. Washer
9. Blade nut
10. Gear case
11. Spark plug wrench
12. String head
13. Connector
14. Grass deflector
15. Screw for grass deflector
16. Locking tab
17. Notch
18. Handle bar
19. Bottom clamp
20. Shaft
21. Throttle trigger
22. Top clamp
I P NL S DK
38 cm
1.2 kW / 1.6 HP
7000 min-
9000 min-
2250-2750 min-
0.85 kg/h
0.45 kg/h
5.8 m/s
6.0 m/s
8.4 m/s
12.5 m/s
102 LpA (dBA)
115 LwA (dBpA)
N FIN GR HU CZ RU
English
23. Latch
24. Strap hanger
3
25. Quick release tap
26. Mounting bracket
27. Best cutting area
28. Dangerous cutting area
1
29. Ignition switch
30. Primer bulb
31. Lever
1
32. Blade protector
1 33. Filter
34. Locking latch
35. Spool
36. Spring
37. Slots for spool
38. Eyelets
39. Cover
40. Anchor hole
2
41. Arrows on spool
2
42. Bump knob
2
43. Guiding pin
2
ASSEMBLY
HANDLE (Fig. 2)
Place the handle bar (18) in the bottom clamp (19)
located on the shaft (20) housing.
Note: The throttle trigger (21) must be mounted to the
operator's right side.
Place the top clamp (22) on top and tighten the four
M5 x 25 screws.
Adjust the handle bar for best operator control in a
comfortable upright position.
ATTACHING THE SHOULDER STRAP (Fig. 3)
Connect the latch (23) on the shoulder strap to the
strap hanger (24).
Adjust the shoulder strap hanger to a balanced
position where the blade or cutter attachment will
suspend between 100 mm to 300 mm above the
ground surface.
Adjust the strap hanger to a comfortable position.
Note: To quickly release the product from the
shoulder strap, sharply pull the quick release tab (25).
GRASS DEFLECTOR AND BLADE GUARD USE
(Fig. 4)
Note: When converting from brushcutter to string trimmer
or string trimmer to brushcutter, make sure the correct
guard/deflector is being used.
22
RO PL SLO HR TR EST LT LV SK BG