Ryobi RY48113 Manual Del Operador página 25

 Position the blade nearest the side discharge chute so that
the ends now point toward the front and back of the mower.
 Measure the distance from the tip of the blade to the ground.
For best results, the front tip of the blade should be from 1/8
in. to 3/8 in. lower than the rear tip.
 If front-to-back adjustment is needed, turn the adjustment
nuts clockwise to raise or counterclockwise to lower the
back of the cutting deck. Each full turn of the adjustment
nut will change the deck height approximately 1/8 in.
NOTE: Make sure to turn the adjustment nuts on both sides
equally to prevent throwing the side-to-side measurement
off again.
 Measure again to verify the front tip is now 1/8 in. to 3/8 in.
lower than the rear tip. If not, continue to adjust and measure
until they are.
 Without moving the adjustment nuts, retighten the jam nuts
to secure the adjustment nuts in place.
REPLACING THE BATTERIES
See Figure 24 - 27.
NOTE: Only use RYOBI Electric Riding Lawn Mower 75Ah
(LPC12-75) or 100Ah (LPC12-100) lead acid batteries.
This mower operates on four 12 volt batteries connected in a
series. If replacing one or more of the batteries, always replace
using a battery of the same type with equal voltage and capacity.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1 and rubber gloves when replacing
the batteries. Failure to do so could result in objects being
thrown into your eyes or other serious personal injury.
Do not open or mutilate the batteries. Released electrolyte
is corrosive and may cause damage to the eyes or skin. It
may be toxic if swallowed.
Do not dispose of the batteries in a fire. The batteries could
explode. Check with local codes for possible special dis-
posal instructions.
Do not expose the battery to rain or keep in damp locations.
Water and liquids can come in contact with the battery and
damage connections and electronic components, which
can result in a short circuit, increased risk of fire, and seri-
ous personal injury.
When batteries are not in use, keep away from other metal
objects like paper clips, coins, keys, nails, screws, or other
small metal objects that can make a connection from one
terminal to another. Shorting the battery terminals together
may cause burns or a fire.
Exercise care in handling batteries in order not to short the
battery with conducting materials such as rings, bracelets,
and keys. The battery or conductor may overheat and cause
serious burns.
MAINTENANCE
25 — English
SEAT
SAFETY
INTERLOCK
CABLE
WIRING
COVER
HEX HD.
BOLT
BATTERY
QUICK-CONNECT
PLUG
TAB
TAB
Fig. 24