Technical Data; Operation Instructions - Surtek RM740 Manual De Usuario Y Garantía

1. TOOL HOLDER(SDS-PLUS).
2. GUIDE RULER.
3. OPERATING MODE SELECTOR KNOB.
4. TRIGGER.
5. AUXILIARY HANDLE.

TECHNICAL DATA

RM740
VOLTAGE-FREQUENCY
NO LOAD SPEED
IMPACTS PER MINUTE
IMPACT ENERGY
CHUCK
POWER
WEIGHT
ASSEMBLY INSTRUCTIONS
WARNING: Remove the grinder from the
carton and examine it carefully. Do not discard
the carton or any packaging material until all
parts are examined.
• Check the power supply: The power tool sup-
ply must match the nameplate date.
• Automatic safety clutch: Protects the opera-
tor and machine from the high reverse torque,
which develops if the tool jams all of a sudden.
INSTALLING THE AUXILIARY HANDLE
Unplug the tool from the
mains socket, firstly. Re-
lease the auxiliary handle
clamping band by turning
the handle in a counter-
clockwise direction. Then
fit the handle band over
the chuck and onto the cy-
lindrical section at the front
end of the tool.
Pivot the auxiliary handle into the desired posi-
tion. Finally, tighten the handle securely to pre-
vent inadvertent movement.
WARNING: Use the auxiliary handle supplied.
Missed operation will cause bodily harm.
SELECTION OF TOOLS
For hammer drilling, SDS-plus tools are neces-
sary that are inserted into the SDS drill chuck of
the machine.
For drilling in steel or wood, driving screws
and cutting threads, tools without SDS-plus
(e.g., drills with cylindrical shafts)are used. For
these tools, a special drill chuck is required
(see APPLICATIONS).
127 V ~ 60 Hz
850 r/min
4 000
4 J
SDS PLUS
1 000 W
3,8 kg (8,3 lb)
E N G L I S H •
INSERTING/REMOVING SDS-PLUS TOOL
The SDS-plus tool is designed to be freely mov-
able. This causes eccentricity when the machine
is not loaded. However the drill automatically
centers itself during operation. This does not af-
fect drilling precision.
WARNING: Take care when changing tools
that the dust cap is not damaged.
a) Inserting: Clean the tool before inserting and
lightly grease the insertion end.
Insert the tool with a twisting motion into the
tool holder until it locks. The tool locks itself.
Check the locking by pulling on the tool.
2) Removing: Pull the plastic sleeve to the rear,
hold it in this position and remove the tool from
the tool holder (see next page image).

OPERATION INSTRUCTIONS

SET THE OPERATING MODE
This Rotary Hammer Drill can be used for drill-
ing wood, metal and masonry. Contained in the
case is a selection of larger SDS Plus masonry
bits. These fit directly into the rotary hammer.
Using the hammer setting the supplied chisels
can be used to break brick work.
Us er 's M an u a l
11