Publicidad
Idiomas disponibles
Idiomas disponibles
3
Configuration of GCU
To configure the controller, please do the instructions that follow:
To enter the configuration mode, push and hold the "STOP" key for at least 3 seconds. The
following screen will appear on the GCU:
If you want to only view the configuration, push the "STOP" key on the GCU. If you wish to
change the configuration, push the "START" key on the GCU.
Figure 4: Configuration mode authentication page screen
The GCU will ask for a password (0000). Enter the password by using the up & down arrow key
for changing the digit and the "START" key for selecting the digit. The 4 digits will start blinking
individually as each one is selected. Press the "START" button as mentioned earlier to enter the
correct digit.
After completion of the parameter configuration, push and hold the "STOP" key to exit from
configuration mode. Before exiting from the configuration mode the controller will show the
following screen:
3.1
List of Parameters
The table that follows gives a brief overview of configurable parameters in GC1030 Series controller.
Table 4: Parameters
Level 0
Module
(MODULE)
Figure 3: Configuration mode screen
Figure 5: Saving settings screen
Level 1 (On screen)
General
(GENERAL)
Level 2 (On screen)
* Power On Mode
(POWER ON MODE)
* Power On Lamp Test
(POWER ON LAMP TEST)
Load Histogram
(LOAD HISTOGRAM)
Auto-Clear Warning Alarm
(WARNING AUTO CLEAR)
Language
(LANGUAGE)
Parameters (On screen)
Manual/Auto
Disable/Enable
Disable/Enable
Disable/Enable
English
Page | 5
Publicidad
