GENERAL INSTRUCTIONS
Before using the unit for the first time, carefully wash the
parts that come in touch with food such as the arm, filter,
container, juicer spout and cones.
Before operating the juicer, make sure to place it on a flat
and stable surface with no heat sources nearby. Assemble
all parts properly before use.
Always place a container under the spout when operating.
To avoid the overheating of the motor, do not use the
appliance for more than 5 minutes continuously, then wait
at least 5 minutes before operating.
Never leave the appliance unattended while it is running.
Do not immerse the motor unit in water or other liquids;
clean it with a damp cloth.
SR54 DESCRIPTION
A) Lid
C) Filter
E) Spout
OPERATING THE UNIT
-
Unroll the power cord from the base (G)
-
Insert the juice container (D) in its housing.
-
Place filters and juicing cones correctly.
-
Make sure that the spout (E) is in the open position.
-
Place a glass or a container under the spout.
-
Connect the electric plug to the power outlet.
-
Cut a citrus in half and place it on the juicing cone.
-
Press over the citrus until the cone rotates
This appliance is suitable to squeeze any type of citrus. It is equipped with two cones (B): a big one with a
wider base for large fruits such as oranges and grapefruit and a smaller one suitable for lemons or small
oranges.
AFTER JUICING
-
Close the spout (E) to prevent juice dripping inside the container (D).
-
Remove the glass with the juice.
-
Remove the filters (C) and the plastic container (D) for cleaning them.
-
Roll the cable on the slot under the base (G).
CLEANING -
Unplug the unit from the electrical outlet.
Some parts (such as the container, filters or juicing cones) can be treated like normal dishes. Wash them
under tap water. For a more accurate cleaning, use a soft sponge and dishwashing detergents.
Plastic parts are not dishwasher-safe.
Clean the motor unit with a damp cloth. Do not immerse the motor unit in water or other liquids.
B) Double juicing cone, small and big
D) Container
F) Motor body
G) Base with power cord housing
9