Publicidad
Idiomas disponibles
Idiomas disponibles
operAtion - General
The appliance is intended only for domestic use, not
for professional use.
1. Fan blades
2. Fan housing
3. Motor housing
4. Oscillation button
5. Stop button
6. Speed buttons
7. Power cord and plug
8. Base
operAtion - before use for the first time
Remove the fan from the packaging and remove all packaging materials.
MontAGe - Assembling the fan
1. U nscrew the locking ring from the motor-housing
shaft (by turning it anticlockwise) and remove the
ring from the shaft.
2. F it the rear of the fan housing (with the grip) onto
the motor-housing shaft, making sure that the
openings are aligned precisely with the lugs on
the motor housing and that the grip is at the top.
3. S lide the locking ring onto the shaft, and screw it
tight.
4. S lide the fan blades onto the shaft.
5. P ress the front half of the fan housing into the
rear part of the fan housing and tighten with the
grips.
6. Tighten the fastening bolt to complete assembly.
operAtion - Ventilation
1. Set the fan on a level surface, such as a table.
2. T ilt the fan to the required angle (see Figure 3).
You can set the fan:
a. t o blow horizontally (position a) or angled
slightly downwards (position b). Tilt the
ventilator housing and motor housing to the
required angle.
b. t o oscillate from left to right (with a sweep of
90 °). This will ventilate much of the room.
Press the oscillation button on the motor
housing fully in.
c. r emain in the same position whilst the fan is
turning. This will ventilate one area. Pull out
the oscillation button until you hear it click.
3. Put the plug into the wall socket.
4. S witch on the fan by pressing one of the two
speed buttons.
2
8
5
6
a
b
16
user's instructions
1
7
4
3
Publicidad
