Ferm CDM1131 Traducción Del Manual Original página 6

Description
The numbers in the text refer to the diagrams on
pages 2 - 3
Fig. A
1. Machine
2. Battery
3. Battery unlock button
5. Charger
6. Charger LED indicator
7. Chuck
8. Gear selection switch
9. Direction switch
10. On / off switch
11. Torque adjustment ring
12. Work light
3. OPERATING
The battery must be charged before first
use.
Removing the battery from the machine
Fig. B1 + B2
• Push the battery unlock buttons (3) and pull
the battery out of the machine like shown in
Fig. B1.
Inserting the battery into the machine
Fig. B1 + B2
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
• Insert the battery (2) into the base of the
machine as shown in Fig. B2.
• Push the battery further forward until it clicks
into place.
Charging the battery (with the charger)
Fig. C
• Plug the charger plug into an electrical outlet
and wait for a while. The LED indicator on
the battery (6) will lighten up and show the
charging status.
6
LED indicator (6)
Fig. C
The battery has 1 LED indicator (6) which
indicates the status of the charging process:
LED Charger status
Red Battery charging in progress
Green Battery charging finished, battery fully charged
• Fully charging the 1.5Ah battery may take up
to 60 minutes.
• After the battery is fully charged remove the
charger plug from the outlet and remove the
battery from the charger.
When the machine is not being used over
a longer period of time it is best to store
the battery in charged condition.
Fitting and removing drills or screwdriver bits
Fig. D
Always remove the battery before
mounting an accessory.
The drill chuck (7) is suitable for drills and screw driver
bits with round shaft as well as hexagonal shaft.
• Hold the machine firmly with one hand
• Open the drill chuck (7) by rotating the chuck
with your other hand in clockwise direction until
it is opened far enough for the bit to slide in.
• Insert the shaft of the drill or screwdriver bit
• Tighten the drill chuck again by firmly rotating
the chuck (7) counterclockwise.
• Check if the bit is centered well by shortly
activating the machine´s on/off switch.
Adjusting the gears
Fig. D
Never switch gears when the motor is
running, this will damage your machine.
Never put switch in the middle between both
positions, this will damage your machine.
The machine has 2 drill speeds, which can be
adjusted by sliding the gear switch (8) forward or
backwards. The number on the gear switch (8)
shows which position is chosen.
• Position 1: For slow drilling, large drilling
diameter or screw driving. The machine has
high power at a low speed.
• Position 2: For fast drilling or small drilling
diameter