Publicidad
Idiomas disponibles
Idiomas disponibles
Operation (continued)
6
Using manual mode
NOTE: Manual mode overrides the motion sensor and
"ON-TIME" control so the light will operate full bright. This
feature only works at night and only for one night at a time.
The motion sensor will reset to motion sensing mode after
6 hours or sunrise, whichever comes first. Manual mode
can be toggled on and off using a wall switch.
□
To turn manual mode on, switch the light off
at the wall switch for 1 to 3 seconds and then
back on.
□
To turn manual mode off, switch the light off
at the wall switch for 1 to 3 seconds and then
back on.
Care and Cleaning
□
To prolong the original appearance, clean the light fixture with clear water and a soft, damp cloth only.
□
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature
deterioration of the finish. This is not a defect in the finish and will not be covered by the warranty.
□
Do not spray the light fixture with a hose or power washer.
Troubleshooting
Problem
The light will not come on.
The light comes on during
the day.
Possible Cause
□
The light switch is turned off.
□
The fuse is blown or the circuit
breaker is turned off.
□
Light bulb is loose or burned out.
□
Daylight turn-off (photocell) is in
effect.
□
The circuit wiring is incorrect (if this
is a new installation).
□
The outside air temperature is close
to the same as a person's body
heat.
□
The motion sensor may be installed
in a relatively dark location.
□
The "ON-TIME" switch is in the
"TEST" position.
10
NOTE: If the power to the light fixture is off for more than
5 seconds, allow the motion sensor to warm up prior to
switching to manual mode.
Turn the switch OFF
for 1 to 3 seconds
Solution
□
Turn the light switch on.
□
Replace the fuse or turn the
circuit breaker on.
□
Check bulb and replace if
burned out.
□
Recheck after dark.
□
Verify the wiring is correct.
□
Increase the "Sensitivity"
setting.
□
The light fixture is operating
normally under these
circumstances.
□
Set the "ON-TIME" switch to the
1, 5, or 10 minute setting.
Turn the switch
back ON
Publicidad
