Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
5
Installing the light bulb
□
Install the bulb (tungsten incandescent,
medium base, type "A", 60 watt maximum -
not included) into the light fixture (A).
□
Place the fixture cap (B) onto the light fixture (A).
□
Secure the fixture cap (B) with the two
decorative screws (EE).
Wiring Options
1
Determining maximum wattage
when adding light fixtures
NOTE: All wiring should be run in accordance with
the National Electrical Code through conduit or another
acceptable means. Contact a qualified electrician if there is
any question as to the suitability of the system.
When controlling an additional light fixture(s), the
maximum wattage of the motion sensor (C) on this light
fixture (A) should be observed. See the illustration to the
right for an example of a maximum lamp wattage load
calculation.
IMPORTANT: When determining the maximum lamp wattage
rating of the light fixture to be controlled, refer to the maximum lamp
wattage label on the fixture and not the wattage rating on the lamp(s)
currently installed in the fixture.
2
Controlling a standard light
fixture(s)
IMPORTANT: Total fixture ratings must not exceed 360 Watts (3.0 A).
When wiring to control a standard light fixture:
□
Strip the red wire on the light fixture (A) and
connect it to the standard light's black wire.
□
Connect all white wires together.
□
Connect all ground wires together.
EE
B
A
Maximum Load for
CONTROLLING Fixture
Motion Sensor –
360 Watts
CONTROLLED Fixture 1
CONTROLLED Fixture 2
White to white
Black to
Motion
black
Sensing
Light
Ground to ground
Wiring the motion sensing light
to control a standard light
7
Please contact 1-855-HD-HAMPTON for further assistance.
Maximum Lamp
Wattage Rating
for Light Fixture –
60 Watts
Maximum Lamp
Wattage Rating
for Light Fixture –
100 Watts
Maximum Lamp
Wattage Rating
for Light Fixture –
100 Watts
TOTAL Load for
Motion Sensor –
260 Watts (100 Watts Remaining)
Standard
Red to
Light
black
HAMPTONBAY.COM
Publicidad
