HAMPTON BAY HBI-4192-WH-D Guía Para El Uso Y Cuidado página 6

Installation (continued)
3
Wiring the light fixture
NOTE: This light fixture can be wired to control another
standard or motion sensing light fixture(s). See Wiring
Options for additional wiring methods.
CAUTION: DO NOT remove wire connector from RED
wire or connect the RED wire unless you want to control
other lights from this motion sensor fixture.
□
Connect the junction box wires to the wires on
the light fixture (A).
□
Using the wire connectors (BB):
□
Connect all white wires together.
□
Connect all black wires together.
□
Recommended grounding method: Attach
a copper wire pigtail (1) (not included) to
the green ground screw on the mounting
bracket (FF).
CC
A
4
Mounting the light fixture base
□
Push the wires into the juction box.
□
Slide the light fixture (A) onto the large
mounting screws (DD) and tighten the
decorative fixture nuts (CC) against the light (A).
□
See the Operation section for testing and
setup.
□
Caulk around fixture base with silicone
weather sealant.
1
FF
BB
□
Connect all ground wires to the pigtail
wire (1) attached to the green ground
screw.
Ground to ground
One motion sensing light
White to white
Light
Ground to ground
Two motion sensing lights (working independently)
CC
A
6
Black to black
Light
White to white
Light
Black to black
DD