Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
continuously reset the heater,
unplug the unit and call technical
support at 1-888-346-7539.
!
NOTE: The heater may emit
a slight, harmless odor when
first used. This odor is a normal
condition caused by initial heating
of internal heater parts and will
not occur again.
Remote Operation
The fireplace is supplied with an
integrated On/Off
!
NOTE: Ensure that the
fireplace 3 position switch is set
to the remote control setting, "II".
To operate, push the ON button
to turn fireplace on, push the OFF
button to turn the fireplace
!
NOTE:
Before attempting any
operation with the remote control,
pull the plastic insulator strip out
from between the remote casing
and battery cover (Figure 5).
Remote Control Initialization/
Reprogram
In the event that your remote
control ceases to operate your
fireplace, follow these steps to
reinitialize the remote control and
the remote control receiver in the
fireplace:
10
remote control.
off.
1. Place the 3-Position Switch
(Figure 4A) in the OFF ("O")
position.
2. Wait a minimum of 5 seconds
and then place the 3-Position
Switch in the Remote Control
position.
3. Within 10 seconds of
changing the switch position,
press the ON button located
on the remote control (Figure
5). This will synchronize
the remote control and the
fireplace receiver.
! NOTE: You will have only 10
seconds to perform this last step.
Failure to do so will result in these
steps needing to be followed
again.
Figure 5
ON
Button
OFF
Button
Plastic Strip
Battery Cover
www.dimplex.com
Publicidad
